jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Engine Controls - Oil Pressure Lamp Illuminated|Page 3341 > < Engine Controls - Oil Pressure Lamp Illuminated|Page 3339
Page 3
background image

Due to the PCM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKREEM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press
"Clear All Stored DTCs" if there are any DTCs shown on the list.

NOTE:

The following step is required by law when reprogramming a PCM and/or TCM.

7.

Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label (Fig. 1).

REPAIR PROCEDURE - USING SOFTWARE UPDATE CD TO RETRIEVE THE FLASH FILE:

NOTE:

Before flashing this module, make sure the StarSCAN(R) is operating at 5.02 or later.

NOTE:

If this flash process is interrupted/aborted, the flash should be restarted.

NOTE:

For detailed information on the operation of the StarSCAN(R), refer to the Quick Reference documentation provided in the StarSCAN(R)
documentation kit. In addition, more recent information may also be available at the www.dcctools.com website. Look under "Training Aids"
and also under "Download Center > Frequently Asked Questions" for more help.

1.

Open the hood, install a battery charger and verify that the charging rate provides approximately 13.5 volts.

2.

Connect the CH9404 StarSCAN(R) vehicle cable to the StarSCAN(R) and the vehicle.

3.

Power ON the StarSCAN(R).

4.

Retrieve the old PCM part number. Using the StarSCAN(R) at the "Home" screen:

a.

Select "ECU View"

b.

Touch the screen to highlight the appropriate ECU (PCM) in the list of modules.

c.

Record the "Part Number", displayed on the "ECU Overview" screen, for later reference.

5.

Insert the StarSCAN(R) Software Update CD into the TechCONNECT or equivalent PC. The StarSCAN(R) Software Update CD will start
automatically.

a.

Select "Download Controller Flash".

b.

Follow the on screen instructions.

6.

At the "Select the method for looking up controller flash updates." screen:

a.

If the old "Part Number" was recorded in Step # 4, proceed to Step # 7.

Engine Controls - Oil Pressure Lamp Illuminated|Page 3341 > < Engine Controls - Oil Pressure Lamp Illuminated|Page 3339