Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
4. Remove the cluster bezel from the instrument panel.
5. Using a trim stick (special tool #C-4755) or equivalent, and gently pry out ignition cylinder bezel.
6. Remove the screws (2) and remove the ignition cylinder (1) by pushing back through the instrument panel.
7. Reach up behind the left side of the center stack and disconnect the ignition switch and SKREEM electrical connectors.
8. Remove the one mounting bolt holding the SKREEM to the ignition cylinder housing.
NOTE: When a PCM and the SKREEM are replaced at the same time refer to Computers and Control Systems/Engine Control Module/Service
and Repair/PCM/SKREEM Programming. See: Relays and Modules - Powertrain Management/Relays and Modules - Computers and Control
Systems/Engine Control Module/Service and Repair/Control Module Programming and Relearning/PCM/SKREEM Programming
Follow this order:
-
Program the new PCM.
-
Program the new SKREEM.
-
Replace an Ignition Keys and program them to the new SKREEM.
INSTALLATION
NOTE: When a PCM and the SKREEM are replaced at the same time refer to Computers and Control Systems/Engine Control Module/Service
and Repair/PCM/SKREEM Programming. See: Relays and Modules - Powertrain Management/Relays and Modules - Computers and Control
Systems/Engine Control Module/Service and Repair/Control Module Programming and Relearning/PCM/SKREEM Programming
Follow this order:
-
Program the new PCM.
-
Program the new SKREEM.
-
Replace all ignition keys and program them to the new SKREEM.
