jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Relays and Modules - Starting and Charging > < Component Locations|Page 486
Page 3
background image

3. Reconnect the instrument panel (3) and body (4) wire harness connectors to the ORC (2) connector receptacles located on the forward facing side

of the module. Be certain that the latches and the red CPA locks on both connectors are each fully engaged.

4. Reinstall the center console onto the top of the floor panel transmission tunnel (1).
5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed

following service of any supplemental restraint system component. 

Relays and Modules - Starting and Charging > < Component Locations|Page 486