Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
1. Remove the rear seat cushion from the vehicle.
2. Loosen the screw (3) that secures the rear outboard seat belt lower anchor and the rear seat back bracket to the rear floor panel.
3. Disengage the lower anchor from the loosened screw.
4. Remove the upper trim from the inside of the C-pillar.
5. Disengage the seat belt lower anchor from the seat belt opening in the upper C-pillar trim.
6. Remove the trim (5) from the quarter inner panel.
7. Remove the screw (2) that secures the seat belt turning loop to the upper C-pillar.
8. Remove the seat belt turning loop from the upper C-pillar.
9. Remove the screw (4) that secures the retractor (1) to the lower C-pillar.
10. Disengage the retractor locator tab from the slot in the lower C-pillar.
11. Remove the rear outboard seat belt and retractor from the lower C-pillar as a unit.
INSTALLATION
1. Be certain that the retractor shield is properly installed in the inner C-pillar and in good condition before installing the retractor.
2. Position the rear seat belt and retractor (1) to the lower C-pillar.
3. Engage the locator tab on the back of the retractor into the slot in the lower C-pillar.
4. Install and tighten the screw (4) that secures the retractor to the lower C-pillar. Tighten the screw to 39 N.m (29 ft. lbs.).
5. Position the seat belt turning loop to the upper C-pillar. Be certain the seat belt webbing between the retractor and the turning loop is not twisted.
6. Install and tighten the screw (2) that secures the seat belt turning loop to the upper C-pillar. Tighten the screw to 39 N.m (29 ft. lbs.).
7. Reinstall the trim (5) onto the quarter inner panel.
8. Route the seat belt lower anchor through the seat belt opening in the upper C-pillar trim.
9. Reinstall the trim onto the upper C-pillar.
10. Engage the seat belt lower anchor under the loosened screw (3) that secures the rear seat back bracket to the rear floor panel. Be certain the seat
belt webbing between the turning loop and the lower anchor is not twisted.
