Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
16.
Looking at the face (outside surface) of the fascia, inspect the face of each sensor to insure that it is centered in its opening and is not contacting
the bracket/applique. Inspect each spacer to ensure that it is evenly spaced between the sensor and bracket/applique (Fig. 2).
NOTE:
The sensor face of each sensor must be centered and not touching the chrome bracket/applique. The new spacer must be evenly spaced around the
side of the sensor face.
17.
Carefully install the energy absorber and the four attaching push pins. Verify that the bracket/applique tabs for the sensors and fascia have not been
damaged.
18.
Position the fascia onto the vehicle and connect the electrical connector.
19.
Slightly spread the sides of the fascia to clear the painted surfaces.
20.
Direct the slot in the upper sides of the fascia onto the t-push pin at each quarter panel wheel opening.
21.
Install the two screws and the four push pin fasteners in the step pad area.
22.
Install the nuts used to retain the each side of the fascia to the quarter panel. Tighten the nuts to 9 Nm (80 in. lbs.).
23.
Install the right rear wheel opening splash shield and the two push pin fasteners used to secure the shield to the body.
24.
Install three new plastic rivets to attach the leading edge of the fascia to the right rear wheel opening splash shield.
25.
Install the left rear wheel opening splash shield and the two push pin fasteners used to secure the shield to the body.
26.
Install three new plastic rivets to attach the leading edge of the fascia to the left rear wheel opening splash shield.
27.
Verify proper assembly.
28.
Close the liftgate and erase any related old DTC's.
