Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
13.
Install the new sensor spacer. Verify that the spacer is correctly installed on the sensor and fully seated (Fig. 1).
14.
Install the sensor with new spacer to the fascia bracket/applique. Hand effort may be higher than normal to fully engage the bracket retention clips
to the sensor. Use hand pressure only to install.
NOTE:
Make sure the clips on each side of the sensor are fully installed to the bracket. Verify that the sensor bracket is fully installed to the applique clips.
15.
Replace the spacers on the remaining three sensors.