Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
a.
Select "Flash Download".
b.
Select "Enter information manually". Press the "Next" button and follow the on screen instructions.
c.
Select the appropriate calibration.
d.
Select "Download to Scantool".
e.
Select "Close" after the download is complete.
11.
Connect the CH9404 StarSCAN vehicle cable to the StarSCAN and the vehicle (if not already connected).
12.
Open the hood, install a battery charger and verify that the charging rate provides approximately 13.5 volts.
13.
Reprogram the LRSM by downloading the file from StarSCAN to the vehicle. Using StarSCAN at the "Home" screen:
a.
Select "ECU View".
b.
Browse the list of controllers using the scroll arrows. Highlight the PCM.
c.
Select "More Options".
d.
Select "ECU Flash".
e.
Highlight the LRSM "Calibration".
f.
Select "Update Controller".
g.
When update is completed, select 'OK". Do not disconnect the DLC cable until this step is complete.
14.
Verify that the LRSM part number has updated. Using the StarSCAN at the "Home" screen:
a.
Select "ECU View".
b.
Touch the screen to highlight the LRSM in the list of modules.
c.
Select "More Options".
d.
Select "ECU Flash".
e.
Verify that the "Part Number", displayed on the "Flash LRSM" screen, has changed to the updated part number.
NOTE:
Due to the LRSM programming procedure, a DTC may be set in other modules (PCM, TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate. Check all modules using "ECU View" from the Home screen, record the DTC's, and erase
these DTC's prior to returning the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.
NOTE:
The following step is required by law.
