Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
1. If the windshield (1) is being reused, remove as much of the original urethane (3) as possible from the glass surface using a razor knife (2).
NOTE:
-
To prevent corrosion, do not damage paint on windshield fence when removing original urethane.
-
The windshield fence should be cleaned of most of its old urethane adhesive. A small amount of old urethane, approximately 1 mm in height
should remain on the fence. Do not completely remove all old urethane from the fence, the paint finish and bonding strength will be adversely
affected. Support spacers located near the cowl at the bottom of the windshield fence should be replaced with new spacers. Replace any
missing or damaged spacers around the perimeter of the windshield fence.
2. Using a razor knife (2), level the original bead of urethane (1) on the windshield fence (3) to a thickness of approximately 1 mm (0.04 in.) and
remove any damaged adhesive backed spacers.
3. Install new adhesive backed spacers (4) along the windshield fence as required.
4. Install a new rubber seal (2) along the top of the windshield (1).
