Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
SPECIAL TOOLS/EQUIPMENT REQUIRED:
REPAIR PROCEDURE - USING THE INTERNET TO RETRIEVE THE FLASH FILE:
NOTE:
The latest released version of the StarSCAN software must be installed on the StarSCAN tool before the "Using The Internet To Retrieve The Flash
File" repair procedure can be performed.
NOTE:
The StarSCAN diagnostic scan tool fully supports Internet connectivity. However, in order to take advantage of this feature you must first configure
the StarSCAN for your dealership's network. For instruction on setting up your StarSCAN for the dealer's network; refer to the StarSCAN Quick
Start Networking Guide available on the website under the "download center".
NOTE:
Make sure the StarSCAN is configured to the dealership's network before proceeding.
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
1.
Connect the CH9404 StarSCAN vehicle cable to the StarSCAN and the vehicle.
2.
Connect the CH9410 StarSCAN ethernet cable to the StarSCAN and the dealer's network drop (optional).
3.
Retrieve the old LRSM part number. Using the StarSCAN at the "Home screen:
a.
Select "ECU View".
b.
Touch the screen to highlight the LRSM in the list of modules.
c.
Select "More Options".
d.
Select "ECU Flash".
e.
Record the "Part Number", displayed on the "Flash LRSM" screen, for later reference.
4.
If the StarSCAN is connected to the dealer's network drop and the vehicle, proceed to Step # 5. If the StarSCAN is not connected to the dealer's
network drop and the vehicle, proceed to Step # 10
5.
Select "Browse for new file".
6.
Select the LRSM calibration.
7.
Select "Download to Scantool".
8.
Select "Close" after the download is complete. Proceed to Step # 11.
9.
Connect the CH9410 StarSCAN ethernet cable to the StarSCAN and the dealer's network drop (if not already connected).
10.
Download the flash file from the Internet to the StarSCAN. Using the StarSCAN at the "Home" screen:
