Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
8.
With the StarSCAN powered OFF, connect the USB Key and Gender Changer to the StarSCAN USB port (Fig. 3).
9.
Open the hood, install a battery charger and verify that the charging rate provides approximately 13.5 volts.
10.
Connect the StarSCAN to the vehicle.
11.
Power ON the StarSCAN.
12.
Download the file from the USB key to the StarSCAN. Using the StarSCAN at the "Home" screen:
a.
Select "Flash Download".
b.
Select "Use USB device".
c.
Follow the on screen instructions. Select "Next" # after each step. Select "Finish" after completing the last step.
d.
At the "Flash File List" screen, highlight the appropriate LRSM "Calibration".
e.
Select "Download to Scantool".
f.
When the download is complete, select "Close".
13.
Reprogram the LRSM by downloading the file from the StarSCAN to the vehicle. Using the StarSCAN at the "Home" screen:
a.
Select "ECU View".
b.
Browse the list of controllers using the scroll arrows. Highlight the PCM.
c.
Select "More Options".
d.
Select "ECU Flash".
e.
Highlight the appropriate LRSM "Calibration" from the list.
f.
Select "Update Controller".
g.
When update is completed, select "OK". Do not disconnect the DLC cable until this step is complete.
