Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
Rain Sensor: Service and Repair
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Disconnect the wire harness connector from the rain sensor module.
3. Using a small screwdriver or equivalent, push in on the tabs from the connector side of the sensor housing until the two sliders (1) protrude from
the opposing side of the housing.
4. Gently pull each slider out from the sensor housing until the cam locks release the sensor from the mounting bracket located on the windshield
glass.
INSTALLATION
1. Verify that the two sliders (1) are positioned in the downward position, sticking out of the side opposite of the rain sensor module connector.
2. Position the rain sensor module over the mounting bracket located on the windshield glass and gently push down to seat it on the bracket.
3. Push the two sliders inward until they are flush with the side of the sensor housing and the cam locks are fully engaged.
4. Connect the wire harness connector to the rain sensor module.
5. Reconnect the negative battery cable.
