Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
Washer Fluid Level Switch: Service and Repair
REMOVAL
NOTE: The washer fluid level switch can be removed from the washer reservoir without removing the reservoir from the vehicle.
1. Disconnect and isolate the negative battery cable.
2. Raise and support the vehicle.
3. Remove the liner from the left front fender wheel house.
4. Disconnect the wire harness connector (1) from the top of the washer fluid level switch (2).
CAUTION: Care must be taken not to damage the reservoir during washer fluid level switch removal.
5. Using a trim stick C-4755 or equivalent, gently pry the barbed nipple of the washer fluid level switch out of the rubber grommet located on the
reservoir (3).
6. Carefully rotate the washer fluid level switch until it can be removed from the reservoir sump and remove and discard the rubber grommet.
INSTALLATION
1. Lubricate a new rubber grommet with clean washer fluid and install it into the washer fluid level switch mounting hole located in the outboard side
of the washer reservoir (3).
2. Position the barbed nipple of the washer fluid level switch (2) to the rubber grommet in the reservoir and press firmly and evenly on the switch
until it is fully seated in the rubber grommet.
3. Connect the wire harness connector (1) to the top of the washer fluid level switch.
4. Install the liner into the left front fender wheel house.
5. Lower the vehicle.