Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
Windshield Washer Pump: Service and Repair
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Raise and support the vehicle.
3. Remove the liner from the left front fender wheel house.
4. Disconnect the wire harness connector (1) from the top of the windshield washer pump (2).
NOTE: To aid in reinstallation, note the installed position of the washer hoses prior to disconnecting them from the windshield washer pump.
5. Disconnect the washer hoses (3) from the barbed outlet nipples of the windshield washer pump and allow the washer fluid to drain into a clean
container for reuse.
CAUTION: Care must be taken not to damage the reservoir during windshield washer pump removal.
6. Using a trim stick C-4755 or equivalent, gently pry the barbed inlet nipple of the windshield washer pump out of the rubber grommet located on
the reservoir (4) and remove and discard the rubber grommet.
INSTALLATION
1. Lubricate a new rubber grommet with clean washer fluid and install it into the washer pump mounting hole located in the outboard side of the
washer reservoir (4).
2. Position the barbed inlet nipple of the windshield washer pump (2) to the rubber grommet in the reservoir and press firmly and evenly on the pump
until it is fully seated in the rubber grommet.
