Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
Wiper Arm: Service and Repair
Front - Wiper Arm
REMOVAL
1. Lift the front wiper arm (1) to its over-center position to relieve the spring tension on the wiper pivot shaft connection.
2. Using a trim stick C-4755 or equivalent, carefully pry off the plastic cap (2) from the pivot end of the wiper arm.
3. Remove the nut (3) that secures the wiper arm to the wiper pivot shaft (4).
4. If necessary, use a suitable battery terminal puller (3) to disengage the wiper arm (1) from the wiper pivot shaft (2).
5. Disengage the front wiper arm pivot from the wiper pivot shaft and remove the front wiper arm.
INSTALLATION
NOTE: Be certain that the wiper motor is in the park position before attempting to install the front wiper arms. Turn the ignition switch to the On
position and move the right (wiper) multi-function switch control knob to its Off position. If the wiper pivots move, wait until they stop moving, then
turn the ignition switch back to the Off position. The wiper motor is now in its park position.
