Grand Cherokee 2WD Limited V8-4.7L (2002)
Fig. 5 Antenna Mast Remove/Install - Typical
8. Unscrew the antenna mast from the antenna base.
9. Remove the plastic shroud from the antenna base cap nut.
Fig. 6 Antenna Base Cap Nut Remove/Install - Typical
10. Remove the antenna base cap nut using an antenna nut wrench (Special Tool C-4816).
11. Remove the antenna escutcheon from the antenna base on the top of the right front fender.
12. Lower the antenna base from the mounting hole in the top of the right front fender.
13. Remove the antenna base and lead from the rear of the right front fender wheel house opening.
INSTALLATION
1. Position the antenna base and lead into the rear of the right front fender wheel house opening.
2. Insert the antenna base into the mounting hole in the top of the right front fender.
3. Install the antenna escutcheon onto the antenna base on the top of the right front fender.
4. Install and tighten the antenna base cap nut using an antenna nut wrench (Special Tool C-4816). Tighten the cap nut to 6.8 Nm (60 in. lbs.).
5. Install the plastic shroud onto the antenna base cap nut.
6. Install and tighten the antenna mast onto the antenna base. Tighten the antenna mast to 3.3 Nm (30 in. lbs.).
7. Reach through the rear of the right front fender wheel house opening to access and insert the antenna lead coaxial cable and connector into the
passenger compartment through the hole in the right cowl side outer panel.
8. From the right front fender wheel house, seat the antenna lead grommet into the hole in the right cowl side outer panel.
9. Install the lower rear half of the inner liner into the right front fender wheel house.
10. Reach under the passenger side of the instrument panel near the right cowl side inner panel to reconnect the antenna coaxial cable connector
halves.
11. Install the trim panel onto the right inner cowl side
