Grand Cherokee 2WD Limited V8-4.7L (2002)
4.
Temporarily position the metal ITM support bracket, p/n 56010689AA, between the two sunroof crossmembers. (Fig. 2)
5.
Center the ITM support bracket so that it is equal distance from the left and right side of the vehicle. Make alignment marks between the ITM
support bracket ends and each sunroof crossmember for later bracket installation.
6.
Make certain that the edge of the ITM support bracket is seated to the rear sunroof crossmember.
7.
Through the holes at the rear edge of the ITM support bracket, mark each location where two holes will need to be drilled for the attaching rivets.
8.
Remove the ITM support bracket.
9.
Drill a 3.175 mm (0.125 inch) diameter hole at the two locations that were previously marked on the rear sunroof crossmember. Be careful that the
drill bit does not contact the roof panel.
10.
Cut two 25 mm (1 inch) long pieces from the original 127 mm (5 inch) long piece of foam tape. The two 25 mm (1 inch) pieces of foam tape will
be used to insulate the metal ITM support bracket from the front sunroof crossmember.
