Grand Cherokee 2WD Limited V8-4.7L (2002)
11.
Attach a 25 mm (1 inch) piece of foam tape to each metal tab on the ITM support bracket. Once installed the two 25 mm (1 inch) pieces of foam
tape should face upward and towards the roof panel. (Fig. 3)
12.
Using the previously made alignment marks, carefully install the front edge of the ITM support bracket to the front sunroof crossmember. Make
sure both 25 mm (1 inch) pieces of foam tape are adhered to both the support bracket and crossmember.
13.
Seat the rear edge of the ITM support bracket to the rear sunroof crossmember. Install both attaching rivets. Make certain the correct length rivet is
used or damage to the sunroof sliding sunshade panel may occur.
14.
Adhere only one side of the remaining 76 mm (3 inch) piece of the foam tape to the center of the ITM snap ring. The tape should be on the side of
the snap ring that will face the roof panel and ITM support bracket. Do not remove the remaining protective facing on the foam tape until the
headliner has been installed. (Fig. 4)
15.
Clean the surface of the ITM support bracket to insure proper adhesion of the foam tape.
