Grand Cherokee 2WD Limited V8-4.7L (2002)
Alarm Module: Service and Repair
Intrusion Transceiver Module Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
Fig.7 Intrusion Transceiver Module Remove
2. While pulling downward lightly on the rear corner of the Intrusion Transceiver Module (ITM) trim cover, insert a small thin-bladed screwdriver
through each of the service holes on the rear edge of the trim cover to release the two integral rear latch features of the module from the mounting
bracket above the headliner.
3. Pull the ITM trim cover rearward far enough to disengage the two front latch features of the module from the mounting bracket above the
headliner.
4. Pull the ITM and trim cover down from the headliner far enough to access and disconnect the overhead wire harness connector for the ITM from
the module connector.
5. Remove the ITM from the headliner.
INSTALLATION
1. Position the Intrusion Transceiver Module (ITM) to the headliner.
2. Reconnect the overhead wire harness connector for the ITM to the module connector.
Fig.8 Intrusion Transceiver Module Retainer Ring