Grand Cherokee 2WD Limited V8-4.7L (2002)
20.
Cycle the ignition key at least twice, from OFF to RUN, to allow the BCM to learn.
21.
Perform the following BCM tasks:
a.
Reset country code setting in the BCM. Perform this operation even if the current country code is correct. This procedure will reset the
BCM. The country code setting is available in the DRBIII(R) Standalone Menu / Body Menu / Miscellaneous Menu.
b.
Cycle the ignition key at least twice, from OFF to RUN, to allow the BCM to learn.
c.
Verify that the EU DRL (European Day Time Running Lights) feature is disabled. If necessary, this feature can be disabled with the
DRBIII(R), and then verified by turning the headlamps and parking lamps to the OFF position and then turning the ignition key to the RUN
position. In this mode, the headlamps and/or parking lamps should not be illuminated if the EU DRL has been disabled.
NOTE:
THE VEHICLE THEFT SECURITY SYSTEM (VTSS) AND ITM MUST BE ENABLED ONCE THE ITM AND BCM HAVE BEEN
REPROGRAMMED.
22.
From the DRBIII(R) Main Menu select DRBIII(R) Standalone (Option 1).
23.
From the Standalone Main Menu select 1998 - 2004 Diagnostics (Option 1).
24.
From the 1998 - 2004 Diagnostic Menu select ALL (Except Below) (Option 1).
25.
From the Select System Menu select Theft Alarm (Option 7).
26.
From the Anti-Theft Systems Menu select VTSS (Option 1). Press ENTER to by-pass transient screen displays.
27.
From the Select Function Menu select Module Display (Option 3). Verify that the ITM S/W Version is 07.05. Press the Page Back key to exit the
Module Display Menu.
28.
From the Select Function Menu select Miscellaneous (Option 9).
29.
From the Miscellaneous Function Menu select Configure ITM (Option 1). Follow the DRBIII(R) instructions for enabling the ITM.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
FAILURE CODE
