jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Liftgate - Will Not Open Correctly|Page 7232 > < Liftgate - Will Not Open Correctly
Page 2
background image

The list shown of recently released liftgate latch system components.

NOTE:

THE LIFTGATE LATCH ACTUATOR (POWER LOCK MOTOR) CAN BE SERVICED SEPARATELY.

REPAIR PROCEDURE:

LIFTGATE, STRIKER, OR BUMPER ADJUSTMENT:

1.

Verify the liftgate is properly centered and is flush with its body opening. Refer to the 2002 Grand Cherokee Service Manual (p/n 81-370-02064)
for additional technical assistance with adjustment. Page 23-9 (Liftgate - Adjustment) and page 23-113 (Gap and Flush).

2.

Verify each liftgate striker (D-Pillar) is positioned correctly to its respective latch. Adjust each striker as necessary.

3.

Verify the sliding wedge and rubber bumpers are not worn such that they lock together and prevent the liftgate from opening smoothly. If either or
both parts are excessively worn, replace and realign for proper contact. The liftgate latch has three positions, one is unlatched and then there are
two latched positions. The first latched position is called the secondary latch position and is the first click sound heard as the latch closes. The
second latch position is the fully latched position (second click of the latch). As the liftgate is closed, the bumper and wedge should be in contact
with each other slightly prior to the time the latch enters its secondary latch position (first click of the latch). The bumper contact timing can be
adjusted by rotating the striker. Verify that the striker loop is centered within the latch "fishmouth" opening. Tighten the striker attaching screws to
28.2 Nm (250 in. lbs.).

LIFTGATE LATCH ACTUATOR (POWER LOCK MOTOR) SERVICE:

1.

Remove the interior liftgate trim panel.

2.

Verify the liftgate latch actuator (power lock motor) operates correctly in both the lock and unlock modes. Refer to the 2002 Grand Cherokee
Service Manual, page 8N-7 (Power Lock Motor), for detailed diagnostic assistance.

NOTE: 

THE LIFTGATE LATCH ACTUATOR (P/N 05018479AB) CAN BE SERVICED SEPARATELY. THE ENTIRE LATCH CONTROL
ASSEMBLY DOES NOT REQUIRE REPLACEMENT IF ONLY THE LATCH ACTUATOR NEEDS TO BE REPLACED.

Liftgate - Will Not Open Correctly|Page 7232 > < Liftgate - Will Not Open Correctly