Grand Cherokee 2WD Limited V8-4.7L (2002)
LIFTGATE LATCH OR CABLE SERVICE:
1.
Remove the interior liftgate trim panel.
2.
Remove the three (3) latch attaching screws.
3.
Remove the latch plate (with rubber bumper).
4.
Remove the latch from the liftgate.
5.
Disconnect the latch cable and electrical connector.
6.
Installation of a latch or cable is the reversal of this process. Tighten attachment screws to 15.8 Nm (140 in. lbs.).
7.
Adjust the latch cable if the latch or cable has been serviced. Refer to the above Latch Cable Adjustment section for directions.
8.
Install the interior liftgate trim panel.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
FAILURE CODE:
Refer to Labor Operation Time Schedule Manual for Appropriate Failure Code.
