jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Body - Sunshade Partially Closes Upon Hard Braking|Page 7621 > < Body - Sunshade Partially Closes Upon Hard Braking
Page 2
background image

8.

Disengage the rear guide blocks from the sunroof track.

9.

Replace all four sunshade guide blocks and springs. Compress the guide block locking tabs to remove the old block and spring (Fig. 1).

NOTE:

MAKE CERTAIN THAT BOTH GUIDE BLOCK AND SPRING ARE REPLACED.

10.

Install the sunshade from outside the vehicle while the sunroof glass panel is in the fully open position.

11.

Engage the rear sunshade guide blocks into their respective sunroof track.

12.

Push the sunshade back and down through the sunroof opening.

13.

Engage the front guide blocks into their respective sunroof track. Position the sunshade so that it is in the half open position.

14.

From inside the vehicle, turn the ignition switch to the "RUN" (ON) position. Move the sunroof glass panel so that its is in a half open position.

15.

Push the sunshade down and rearward (toward its fully open position) until the sunshade tabs clear the glass.

16.

Verify full and proper operation of the sunshade and sunroof glass.

17.

Turn the ignition switch to the "OFF" position.

POLICY:
Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

Body - Sunshade Partially Closes Upon Hard Braking|Page 7621 > < Body - Sunshade Partially Closes Upon Hard Braking