Grand Cherokee 2WD Limited V8-4.7L (2002)
44. Connect the seatback wiring to the seat cushion wiring harness.
45. Route the "J" strap under the seat frame and latch the rear "J" strap to the seat frame wire.
46. Connect the power seat switch harness to the seat switch and place the outer seat cushion plastic trim panel into position. Install and tighten the
three fastening screws.
47. Repeat steps 8 through 46 on the remaining front seat.
48. With the help of an assistant, place the front seats into the vehicle.
49. Connect the power seat wiring connector to the body harness.
50. Install seats into position and install the fasteners. Tighten the fasteners to 30 ft. lbs. (40 N.m).
52. Install the headrests on both front seats.
53. Connect the negative battery cable and close the hood.
