Grand Cherokee 2WD Limited V8-4.7L (2002)
3. Remove the caliper anchor bolts.
4. Remove caliper and anchor as an assembly.
5. Secure caliper anchor assembly to nearby suspension part with wire. Do not allow brake hose to support caliper weight.
6. Remove retainers securing rotor to axle studs.
7. Remove rotor off axle studs.
Front Brake Rotor
INSTALLATION - FRONT DISC BRAKE ROTOR
NOTE: If a new rotor is installed it must be match mounted to the hub/ bearing.
1. Install rotor on hub studs in its original location.
2. Install the caliper anchor assembly on the knuckle. Install anchor bolts and tighten to 90 - 115 Nm (66 - 85 ft. lbs.).
3. Install wheel and tire assembly.
4. Remove support and lower the vehicle.
5. Pump brake pedal to seat caliper pistons and brake shoes. Do not move vehicle until firm brake pedal is obtained.
Rear Brake Rotor
INSTALLATION - REAR DISC BRAKE ROTOR
1. Install rotor on axle studs.
2. Install the caliper anchor assembly.
3. Install anchor bolts and tighten to 90 - 115 Nm (66 - 85 ft. lbs.).
4. Install wheel and tire assembly.
5. Remove support and lower the vehicle.
6. Pump brake pedal until caliper pistons and brake shoes are seated.
