Grand Cherokee 2WD Limited V8-4.7L (2002)
14.
Install two new caliper assembly attaching bolts (included in front brake package) Tighten each bolt to 90 - 115 Nm (66 - 85 ft. lbs.).
15.
Verify that the brake hose banjo fitting, attaching bolt, and caliper port are clean.
16.
Install a new copper gasket washer (included in front brake package) on each side of the brake hose banjo fitting.
17.
Using a banjo bolt, attach the brake hose fitting and new copper gasket washers to the caliper.
NOTE:
VERIFY THAT THE BRAKE HOSE IS NOT TWISTED OR KINKED. MAKE SURE THE HOSE IS ROUTED PROPERLY.
18.
Tighten the attaching banjo bolt to 31 Nm (23 ft. lbs.) (Fig. 3).
19.
Repeat steps 4 to 18 on the opposite side brake caliper assembly.
20.
Fill and bleed the brake system. Pump the brake pedal to insure that the front caliper brake pads are seated to the brake rotors. Check brake fluid
level frequently.
21.
Install both front wheel and tire assemblies. Tighten the front lug nuts to 135 Nm (100 ft lbs.). This important step helps to prevent warping of the
brake rotor(s)
22.
Lower vehicle.
23.
Verify correct brake fluid level and brake system operation.
