Grand Cherokee 2WD Limited V8-4.7L (2002)
7. Remove the caliper slide pin bushing caps and remove the slide pins.
8. Remove caliper from the anchor.
Inboard Brake Shoe
9. Remove the inboard brake shoe.
Front
INSTALLATION - FRONT DISC BRAKE CALIPER
1. Install the inboard brake shoe.
2. Lubricate the slide pins and slide pin bushings with Dow Corning grease G807 or the grease provided with the caliper.
3. Install the caliper on the anchor.
4. Install the caliper slide pin and tighten to 29 - 41 Nm (21 - 30 ft. lbs.).
5. Install the caliper slide pin bushing caps.
6. Install the caliper support spring in the top end of the caliper and under the anchor. Then install other end into the lower caliper hole. Hold the
