Grand Cherokee 2WD Limited V8-4.7L (2002)
Fig.25 Left Multi-Function Switch Remove/Install
5. Remove the screws that secure the left multifunction switch to the housing.
6. Remove the left multi-function switch.
INSTALLATION
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT
AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM
CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO
DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG
DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
Fig.28 Left Multi-Function Switch Remove/Install
1. Position the left multi-function switch onto the housing (Fig. 28).
2. Install and tighten the screws that secure the left multi-function switch housing. Tighten the screws to 2.5 Nm (22 in. lbs.).
3. Reconnect the instrument panel wire harness connector to the switch connector.