Grand Cherokee 2WD Limited V8-4.7L (2002)
NOTE:
Remove the connector clip from the reinforcement bracket and attach it to the connector if necessary.
51.
Install the brush guard/skid plate-to-frame brace at the front of the fuel tank (Figure 11).
52.
Attach the fuel pump module connector to the brace (Figure 11).
53.
Install the two (2) rear brush guard/skid plate-to-frame support braces (Figure 10).
54.
Install the four (4) rear fascia-to-fuel tank push pins (Figure 9).
55.
Install the left rear stone shield using the supplied plastic rivets (Figure 1).
56.
Install the left rear wheel and tire assembly. Tighten the lug nuts to 100 ft-lbs (136 N.m).
57.
Lower the vehicle.
58.
Connect the negative battery cable.
59.
Refill the fuel tank and then start the engine and verify that there are no fuel leaks.
