jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Recall - Fuel Filler Inlet Check Valve|Page 3614 > < Recall - Fuel Filler Inlet Check Valve|Page 3612
Page 4
background image

10.

On the DRB III, select # 1 - DRB STANDALONE.

11.

Select # 1 - 1998-2002 DIAGNOSTICS.

12.

Select # 1 - ALL (EXCEPT BELOW).

13.

Select # 1 - ENGINE.

14.

Select # 1 - SYSTEM TESTS.

15.

Select # 7 or # 8 - LDP MONITOR TEST.

NOTE:

The selection number depends upon what options the vehicle is equipped with. Be sure to select the LDP Monitor Test.

16.

Follow the instructions on the screen to complete the LDP monitor test.

NOTE:

The test will take approximately 3-5 minutes to run.

17.

After the test is completed, press ENTER.

18.

Press ENTER again to go back to the SYSTEM TEST menu.

19.

Press PAGE BACK.

20.

Select # 2 - DTCs & RELATED FUNCTIONS.

21.

Select # 1 - READ DTCs.

22.

Press PAGE BACK for ONE TRIP DETECTION.

23.

Press PAGE BACK to read codes. Determine if any evaporative system one-trip faults are stored and then record the fault code if present.

24.

Turn engine off and then turn the ignition key to the ON position.

25.

Press PAGE BACK.

26.

Press YES to erase any DTCs.

27.

If the vehicle had a one trip fault or fault code for LDP System Fault - LARGE Leak Detected, the fuel tank must be replaced. Continue with
Section B. - Replace Fuel Tank.

If the vehicle had no faults or only had a SMALL or MEDIUM Leak Detected, no further action is necessary. Continue with Step 28.

28.

Remove the clamp from the fuel filler recirculation hose.

29.

Install the fuel filler cap.

30.

Install the left rear stone shield using the supplied plastic rivets (Figure 1).

31.

Install the left rear wheel and tire assembly. Tighten the lug nuts to 100 ft-lbs (136 N.m).

32.

Lower the vehicle and return it to the customer.

B. Replace Fuel Tank

Recall - Fuel Filler Inlet Check Valve|Page 3614 > < Recall - Fuel Filler Inlet Check Valve|Page 3612