Grand Cherokee 2WD Limited V8-4.7L (2002)
Throttle Body: Service and Repair
REMOVAL
1. Remove the air duct and air resonator box at throttle body.
Fig. 36 Throttle Body, Sensors And Electrical Connectors - 4.7L V-8 Engine
2. Disconnect throttle body electrical connectors at IAC motor and TPS (Fig. 36).
3. Remove vacuum line at throttle body.
4. Remove all control cables from throttle body (lever) arm. Refer to Accelerator Pedal and Throttle Cable.
5. Remove three throttle body mounting bolts (Fig. 36).
6. Remove throttle body from intake manifold.
INSTALLATION
1. Clean throttle body-to-intake manifold O-ring.
2. Clean mating surfaces of throttle body and intake manifold.
3. Install throttle body to intake manifold by positioning throttle body to manifold alignment pins.
4. Install three mounting bolts. Tighten bolts to 12 Nm (105 in. lbs.) torque.
5. Install control cables.
6. Install vacuum line to throttle body.
7. Install electrical connectors.
8. Install air duct/air box at throttle body.
