Grand Cherokee 2WD Limited V8-4.7L (2002)
Fig. 30 IAT Sensor Tab/O-Ring - 4.7L (Snap-In Type)
Fig. 29 IAT Sensor - 4.7L (Snap-In Type)
3. Gently lift on small plastic release tab and rotate sensor about 1/4 turn counterclockwise for removal.
4. Check condition of sensor O-ring.
INSTALLATION
Threaded Type Sensor
1. Install sensor into intake manifold. Tighten sensor to 28 Nm (20 ft. lbs.) torque.
2. Connect electrical connector to sensor.
Snap-In Type Sensor
1. Check condition of sensor O-ring.
2. Clean sensor mounting hole in intake manifold.
3. Position sensor into intake manifold and rotate clockwise until past release tab.
