Grand Cherokee 2WD Limited V8-4.7L (2002)
12. Remove the front wiper module from the cowl plenum as a unit.
INSTALLATION
1. Position the front wiper module into the cowl plenum as a unit.
2. Lift the left end of the front wiper module far enough to access the front wiper motor wire harness connector.
3. Reconnect the left headlamp and dash wire harness connector for the front wiper motor to the front wiper motor pigtail wire connector.
4. Loosely install one of the front wiper module mounting screws to the mounting hole near the pivot on the right end of the module to locate the
module in the plenum.
5. Working from left to right, install and tighten the four screws that secure the front wiper module to the cowl plenum panel. Tighten the screws to 8
Nm (72 in. lbs.).
6. Position the cowl grille cover onto the cowl plenum and cowl top panels through the opening between the hood and the base of the windshield.
7. Lift the left end of the cowl grille cover off of the cowl plenum panel far enough to access the front washer plumbing.
8. Reconnect the front washer system engine compartment hose to the cowl grille cover hose at the elbow connector.
9. Install the six plastic nuts that secure the cowl grille cover to the studs on the cowl top panel near the base of the windshield. These nuts are to be
installed by pushing them onto the studs in the following sequence:
a. First, install the short nuts to the third stud from the right, then the second stud from the left.
b. Next, install long nuts to the right outboard stud, then the left outboard stud.
c. Finally, install the two remaining long nuts to the third stud from the left, then the second stud from the right.
10. Starting at the ends and working toward the center, push the hood to plenum seal onto the forward flanges of the cowl grille cover and the plenum
panel.
11. Close and latch the hood.
12. Reinstall the wiper arms onto the wiper pivots. (Refer to ELECTRICAL/FRONT WIPERS/WASHERS/FRONT WIPER ARMS -
INSTALLATION).
13. Reconnect the battery negative cable.
