Grand Cherokee 2WD Limited V8-4.7L (2002)
48.
Install the HVAC control unit.
49.
Install the radio.
50.
Install the radio bezel.
51.
Connect the heated seat switch, lighter and auxiliary power outlet electrical connectors and then install the ash tray bezel.
52.
Install the front bin into the center floor console.
53.
Install the left and right A-Pillar trim panels.
54.
Install the I/P top cover (Figure 1). Make sure that the four (4) snap clip retainers are engaged.
55.
With the ignition switch in the ON position, connect the negative battery cable.
56.
From outside the vehicle, turn the ignition switch to the OFF position for about 10 seconds and then back to the ON position.
57.
Observe the airbag warning light in the instrument cluster. It should illuminate for 6-8 seconds and then go out.
NOTE:
If the airbag warning light fails to light or lights and stays on, there is a system malfunction. Refer to the proper Body Diagnostic Procedures
manual to diagnose and repair the problem.
