Grand Cherokee 2WD Limited V8-4.7L (2002)
Fig.12 PDC Relay Cassette Latches - Typical
2. From the top of the PDC housing, use a small screwdriver or a terminal pick tool (Special Tool Kit 6680) to release the two latches that secure the
relay cassette in the PDC (Fig. 12).
3. Gently and evenly press the relay cassette down through the PDC housing.
Fig.13 PDC Relay - Typical
4. From the bottom of the PDC housing, remove the relay cassette from the PDC (Fig. 13).
CAUTION: Do not remove the wiring and terminals from the terminal cavities of the faulty PDC relay cassette at this time. Refer to the Assembly
procedure that follows for the proper procedures for transferring the wiring and terminals to the replacement PDC relay cassette.
ASSEMBLY
PDC B(+) Terminal Module Installation
1. From the bottom of the PDC housing, align and insert the B(+) terminal module into the PDC.
2. From the bottom of the PDC housing, align and insert the two studs of the PDC B(+) terminal module through the bus bar in the PDC.
