Grand Cherokee 2WD Limited V8-4.7L (2002)
lower bearing.
11. Turn the gear over and remover the upper bearing with Driver 8277 and Handle C-4171.
INSTALLATION
1. Install upper pitman shaft bearing, with Driver 8294 and Handle C-4171. Drive bearing into housing until the driver bottoms out.
NOTE: Install upper pitman shaft bearing with the part number/letters facing the driver.
2. Install lower pitman shaft bearing with the other side Driver 8294 and Handle C-4171. Drive bearing into housing until the bearing shoulder is
seated against the housing.
3. Coat the oil seal and backup washers with special grease supplied with the new seal.
4. Install the oil seal with Driver 8294 and Handle C-4171.
5. Install plastic backup washer.
NOTE: The plastic backup washer has a lip on the inside diameter that faces down towards the oil seal.
6. Install metal backup washer.
7. Install the retainer ring with snap ring pliers.
8. Coat the dust seal with special grease supplied with the new seal.
9. Install dust seal with Driver 8294 and Handle C-4171.
10. Install new pitman shaft cover O-ring.
11. Install pitman shaft assembly into the housing.
12. Install cover bolts and tighten to 62 Nm (46 ft. lbs.).
13. Perform over-center rotation torque adjustment.
