Grand Cherokee 2WD Limited V8-4.7L (2002)
5. Disconnect the transfer case shift cable from the transfer case shift lever pin (Fig. 107), if equipped.
6. Remove the clip holding the transfer case shift cable to the shifter assembly bracket, if equipped.
7. Remove the transfer case shift cable from the shifter assembly bracket, if equipped.
8. Disengage all wiring connectors from the shifter assembly.
9. Remove all nuts holding the shifter assembly to the floor pan (Fig. 108).
10. Remove the shifter assembly from the vehicle.
INSTALLATION
1. Place the floor shifter lever in PARK position.
2. Loosen the adjustment screw on the shift cable.
3. Verify that the park lock cable adjustment tab is pulled upward to the unlocked position.
4. Install wiring harness to the shifter assembly bracket. Engage any wire connectors removed from the shifter assembly.
5. Install the transfer case shift cable to the shifter assembly bracket. Install clip to hold cable to the bracket.
6. Snap the transfer case shift cable, if equipped, onto the transfer case shift lever pin.
7. Install the park lock cable into the shifter assembly bracket and into the shifter BTSI lever.
8. Install the shift cable to the shifter assembly bracket. Push cable into the bracket until secure.
9. Install shifter assembly onto the shifter assembly studs on the floor pan.
10. Install the nuts to hold the shifter assembly onto the floor pan. Tighten nuts to 28 Nm (250 in. lbs.).
11. Snap the shift cable onto the shift lever pin.
12. Verify that the shift lever is in the PARK position.
13. Tighten the adjustment screw to 7 Nm (65 in. lbs.).
14. Place the key in the accessory position.
15. Push downward on the park lock cable adjustment tab to lock the adjustment.
16. Verify correct shifter, park lock, and BTSI operation.
