Grand Cherokee 2WD Limited V8-4.7L (2002)
12. Using Spanner Wrench 6958 and a torque wrench set at 474 Nm (350 ft. lbs.), (Fig. 86) slowly tighten the nut in 6.8 Nm (5 ft. lbs.) increments
until the rotating torque is achieved. Measure the rotating torque frequently to avoid over crushing the collapsible spacer (Fig. 87).
NOTE: If more than 474 Nm (350 ft. lbs.) torque is required to crush the collapsible spacer, the spacer is defective and must be replaced.
13. Check bearing rotating torque with a inch pound torque wrench (Fig. 87). The pinion gear rotating torque should be:
-
Original Bearings: 1 - 2.25 Nm (10 - 20 in. lbs.).
-
New Bearings: 1.7 - 3.9 Nm (15 - 35 in. lbs.).
14. Invert the differential case and start two ring gear bolts. This will provide case-to-ring gear bolt hole alignment.
15. Invert the differential case in the vise.
16. Install new ring gear bolts and alternately tighten to 136 Nm (100 ft. lbs.) (Fig. 88).
