Grand Cherokee 2WD Limited V8-4.7L (2002)
10. Remove pinion gear seal with Remover 7794-A and slide hammer (Fig. 33).
INSTALLATION
1. Apply a light coating of gear lubricant on the lip of pinion seal and install seal with an appropriate installer (Fig. 34).
2. Install yoke on pinion gear with Screw 8112, Cup 8109 and Spanner Wrench 6958 (Fig. 35).
CAUTION: Do not exceed the minimum tightening torque 271 Nm (200 ft. lbs.) when installing the pinion yoke at this point. Damage to the
collapsible spacer or bearings may result.
