Grand Cherokee 2WD Limited V8-4.7L (2002)
Wiper Control Module: Service and Repair
Rear Wiper Module Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear wiper arm from the rear wiper motor output shaft. (Refer to ELECTRICAL/REAR WIPERS/WASHERS/REAR WIPER ARM -
REMOVAL).
Fig.13 Rear Wiper Motor Output Shaft Remove/Install
3. Use a door trim panel removal tool to gently pry at the base of the nut cover where it meets the wiper motor output shaft bezel and gasket on the
outer liftgate panel until it unsnaps from the beze. Be certain to use proper caution to protect the outer liftgate panel and its paint finish from
damage during this procedure.
4. Remove the nut that secures the rear wiper motor output shaft to the outer liftgate panel.
5. Remove the bezel and gasket from the rear wiper motor output shaft.
6. Remove the trim panel from the inside of the liftgate.
