Grand Cherokee 4WD L6-242 4.0L VIN S MFI (1993)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor
REMOVAL
1. Disconnect negative battery cable.
2. Disconnect sensor electrical connector, located near distributor.
3. Remove clip holding wires to motor mount.
4. Remove sensor mounting bolts.
5. Remove the sensor from vehicle.
6. Remove clip from sensor wiring harness.
INSTALLATION
1. Position camshaft position sensor flush against the distributor.
2. Install sensor mounting bolts or nuts.
3. Connect the electrical connector to the sensor.
4. Install clip on sensor wire.
5. Install clip on motor mount.