Grand Cherokee 4WD V8-318 5.2L VIN Y MFI (1994)
Electronic Brake Control Module: Service and Repair
1. Turn ignition switch to Off position.
2. Disconnect battery ground cable, then remove air cleaner and hoses.
3. Remove screws attaching CAB to fender panel bracket.
4. Lift CAB out of engine compartment to gain access to harness connector.
5. Release strap securing harness connector to CAB pin terminals.
6. Disconnect and separate harness connector by tilting it upward to disengage from CAB pin terminals, then slide it out of retaining tangs.
7. Reverse procedure to install.
