Grand Cherokee 4WD V8-4.7L (2003)
1. Position the front wiper module to the cowl plenum as a unit.
2. Lift the left end of the front wiper module far enough to access the front wiper motor wire harness connector.
3. Reconnect the left headlamp and dash wire harness connector for the front wiper motor to the motor pigtail wire connector.
4. Loosely install one of the front wiper module mounting screws to the mounting hole near the pivot on the right end of the module to locate the
module in the plenum.
5. Working from left to right, install and tighten the four screws that secure the front wiper module to the cowl plenum panel. Tighten the screws to 8
Nm (72 in. lbs.).
6. Reinstall the cowl plenum cover/grille panel over the cowl plenum.
7. Reinstall both front wiper arms onto the wiper pivots.
8. Reconnect the battery negative cable.
9. Close and latch the hood.