Grand Cherokee 4WD V8-4.7L (2003)
Malfunction Lamp / Indicator: Description and Operation
AIRBAG INDICATOR
An airbag indicator is standard equipment on all instrument clusters. However, the instrument cluster is programmed to automatically enable this
indicator only on vehicles equipped with the airbag system, which is not available in some markets. The airbag indicator is located on the upper edge
of the instrument cluster, between the speedometer and the tachometer. The airbag indicator consists of the words "AIR BAG imprinted on a red lens.
The lens is located behind a cutout in the opaque layer of the instrument cluster overlay. The dark outer layer of the overlay prevents the indicator
from being clearly visible when it is not illuminated. The "AIR BAG" text appears silhouetted against a red field through the translucent outer layer of
the overlay when the indicator is illuminated from behind by a Light Emitting Diode (LED), which is soldered onto the instrument cluster electronic
circuit board. The airbag indicator lens is serviced as a unit with the instrument cluster lens, hood and mask unit.
The airbag indicator gives an indication to the vehicle operator when the airbag system is faulty or inoperative. The airbag indicator is controlled by a
transistor on the instrument cluster circuit board based upon cluster programming and electronic messages received by the cluster from the Airbag
Control Module (ACM) over the Programmable Communications Interface (PCI) data bus. The airbag indicator Light Emitting Diode (LED) is
completely controlled by the instrument cluster logic circuit, and that logic will only allow this indicator to operate when the instrument cluster
receives a battery current input on the fused ignition switch output (RUN/START) circuit. Therefore, the indicator will always be off when the ignition
switch is in any position except On or Start. The LED only illuminates when it is switched to ground by the instrument cluster transistor. The
instrument cluster will turn on the airbag indicator for the following reasons:
-
Bulb Test - Each time the ignition switch is turned to the On position the airbag indicator is illuminated for about six seconds. The entire six
second bulb test is a function of the ACM.
-
ACM Lamp-On Message - Each time the cluster receives a lamp-on message from the ACM, the airbag indicator will be illuminated. The
indicator remains illuminated for about 12 seconds or until the cluster receives a lamp-off message from the ACM, whichever is longer.
-
Communication Error - If the cluster receives no airbag messages for six consecutive seconds, the airbag indicator is illuminated. The indicator
remains illuminated until the cluster receives a single lamp-off message from the ACM.
-
Actuator Test - Each time the cluster is put through the actuator test, the airbag indicator will be turned on, then off again during the bulb check
portion of the test to confirm the functionality of the LED and the cluster control circuitry. The actuator test illumination of the airbag indicator is
also a function of the ACM.
The ACM continually monitors the airbag system circuits and sensors to decide whether the system is in good operating condition. The ACM then
sends the proper lamp-on or lamp-off messages to the instrument cluster. If the ACM sends a lamp-on message after the bulb test, it indicates that the
ACM has detected a system malfunction and/or that the airbags may not deploy when required, or may deploy when not required. The ACM will store
a Diagnostic Trouble Code (DTC) for any malfunction it detects. Each time the airbag indicator fails to illuminate due to an open or short in the
cluster airbag indicator circuit, the cluster sends a message notifying the ACM of the condition, then the instrument cluster and the ACM will each
store a DTC. For proper diagnosis of the airbag system, the ACM, the PCI data bus, or the electronic message inputs to the instrument cluster that
control the airbag indicator, a DRBIII scan tool is required Refer to the appropriate diagnostic information.
