Grand Cherokee 4WD V8-4.7L (2003)
Power Steering Fluid Reservoir: Service and Repair
RESERVOIR
REMOVAL
1. Remove power steering pump.
2. Clean exterior of pump.
3. Clamp the pump body in a soft jaw vice.
NOTE: Use new retaining clips for installation.
4. Pry up tab and slide the retaining clips off.
5. Remove fluid reservoir from pump body. Remove and discard O-ring seal.
INSTALLATION
1. Lubricate new O-ring Seal with Mopar Power Steering Fluid or equivalent.
2. Install O-ring seal in housing.
3. Install reservoir onto housing.
4. Slide and tap in new reservoir retainer clips until tab locks to housing.
5. Install power steering pump.
6. Add power steering fluid.
