Grand Cherokee 4WD V8-4.7L (2003)
3. Place a bearing cap over the trunnion and align the cap with the yoke bore (Fig. 16). Keep the needle bearings upright in the bearing cap.
4. Press the bearing cap into the yoke bore enough to clear snap ring groove.
5. Install a snap ring.
6. Repeat Step 3 and Step 4 to install the opposite bearing cap.
NOTE: If the joint is stiff or binding, strike the yoke with a soft hammer to seat the needle bearings.
7. Add grease to lube fitting, if equipped.
8. Install the propeller shaft.
