Grand Cherokee 4WD V8-4.7L Flex Fuel (2009)
Amplifier: Service and Repair
Amplifier - Installation
INSTALLATION
WARNING: On vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering
column, driver airbag, passenger airbag, seat belt tensioner, side curtain airbag, front impact sensor, side impact sensor, or
instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two
minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable
the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment and
possible personal injury.
1. Position the amplifier into place.
2. Install and tighten the mounting fasteners.
3. Connect the two wire harness connectors.
4. Install the left quarter trim panel.
5. Connect the battery negative cable.
