Grand Cherokee 4WD V8-4.7L Flex Fuel (2009)
Integrated Accessory Switch Assembly: Service and Repair
Instrument Cluster Switch Pod - Removal
Lower
LOWER
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel from the instrument panel.
3. Disconnect the wire harness connector from the back of the lower instrument panel switch pod (1).
4. Remove the four screws (2) that secure the switch pod to the back of the center bezel.
5. Remove the lower switch pod from the center bezel.
Upper
UPPER
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
