Grand Cherokee 4WD V8-4.7L Flex Fuel (2009)
FRONT
1. Install the caliper (5) on the adapter (2).
2. Caliper slide pins should be free from debris and lightly lubricated.
3. Install the caliper slide pin bolts (2) and tighten to 44 Nm (32 ft. lbs.).
4. Gently lift one end of the slide pin boot to equalize air pressure, then release the boot and verify that the boot is fully covering the slide pin.
CAUTION: Verify brake hose is not twisted or kinked before tightening banjo bolt.
5. Install brake hose (5) to caliper (1) with new copper washers (6) and tighten banjo bolt (6) to 31 Nm (23 ft. lbs.).
6. Remove the prop rod from the brake pedal.
7. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be
performed.See: Brake Bleeding/Service and Repair.
8. Install wheel and tire assemblies.
9. Remove supports and lower vehicle.
10. Verify brake fluid level.
Rear
