Grand Cherokee 4WD V8-4.7L Flex Fuel (2009)
Glove Box Lamp: Service and Repair
Glove Box Lamp Bulb - Installation
BULB
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. Reach through and above the instrument panel glove box opening to align the base of the bulb with the bulb holder on the lower side of the glove
box lamp and switch unit (1).
2. Push the bulb straight into the bulb holder until the base is firmly seated.
3. Close the glove box.
4. Reconnect the battery negative cable.
