Grand Cherokee 4WD V8-4.7L Flex Fuel (2009)
Tail Light Bulb: Service and Repair
Tail Stop Turn Lamp Bulb - Installation
BULB - DOMESTIC
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The rear lamp unit for domestic markets (1) contains two bulbs: park/rear side marker/stop/turn signal (2) and backup (3). The
service procedures for each bulb are the same, only the bulb sizes and types may differ.
1. Align the base of the bulb with the bulb socket (2 or 3).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of the rear lamp unit housing.
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reinstall the rear lamp unit onto the end of the quarter panel. See: Brake Lamp/Service and Repair/Tail Stop Turn Lamp - Installation.
7. Reconnect the battery negative cable.
